XC60 FWD L6-3.2L VIN 96 B6324S2 (2010)
The service message is displayed the first time the ignition is switched on after the service interval has been reached.
There are three types of service message that consist of a text string and they are displayed for different amounts of time when the ignition is switched
on.
-
30 days remaining until service. Displayed for 60 seconds.
-
Time for service. Displayed for 120 seconds.
-
Service should have already been carried out. Displayed for 240 seconds.
The service message will be displayed each time the ignition is switched on, until it is reset.
The conditions for the display of the service message can be programmed for three different parameters:
-
mileage
-
time passed
-
engine hours.
The quality of the engine oil also has an impact on when the message is displayed. However this parameter cannot be programmed.
Resetting the service message
The service message can be reset using the diagnostic tool or as follows:
-
Set the vehicle to ignition position I.
-
Press and hold in the reset button for the trip meter.
-
Ignition position II.
-
Wait 10 seconds.
-
Release the reset button when the information light starts to flash.
Engine coolant temperature (ECT)
The engine control module (ECM), (4/46) processes the value it receives from the engine coolant temperature (ECT) sensor. The processed value is then
transmitted to the central electronic module (CEM) (4/56) on the high speed section of the control area network (CAN). The central electronic module
(CEM) receives the signal and generates a corresponding signal on the low speed section of the control area network (CAN). The driver information
module (DIM) (5/1) reads the signal from the low speed section of the control area network (CAN).
The driver receives information via a text message and a warning lamp if the temperature becomes too high.
Parking brake