XC60 FWD L6-3.2L VIN 96 B6324S2 (2010)
Fuel level ejector side (only vehicles with AWD)
Shows current fuel level in liters on the ejector side.
If the total fuel level for both pump and ejector side is > 9 liters, the ejector side's volume will never show less than 5 liters.
Description of Frozen Values, DIM
Description of frozen values
Explanation
Frozen values are parameter values that are stored when a diagnostic trouble code (DTC) is stored.
Not all parameters can be read off for all diagnostic trouble codes (DTCs). The parameter values can only be read off where they can provide more
information about the prevailing circumstances when the diagnostic trouble code (DTC) was stored.
Total mileage, value
Measurement range: 0-1,000,000 km
The value indicates the vehicle's total mileage when the Diagnostic Trouble Code (DTC) was generated.
MECU power supply, value
Measurement range 0-63 V
Normal range: 12.0-14.5 V
The value indicates the supply voltage to the central electronic module (CEM) when the diagnostic trouble code (DTC) was stored.
Passenger compartment temperature, value
Measurement range: -40 to +215 °C
The value indicates the passenger compartment temperature when the diagnostic trouble code (DTC) was stored
Outside temperature, value
Measurement range: -40 to +215 °C
The value indicates the outside temperature when the diagnostic trouble code (DTC) was stored
Power supply position, status
The value indicates the current status of the power supply position when the diagnostic trouble code (DTC) was stored
Key removed
Key recently removed
Key approved
Ignition off after Accessory position
Accessory position
Accessory position after Ignition on
Ignition on
Running
Start attempts
Description of the Programmed Values
Description of the programmed values
Programming the distance conditions for service
This parameter is used to indicate the number of kilometers the vehicle may be driven before the service reminder indicator (SRI) lights.
The following values may be selected for driver information modules (DIM) intended for kilometers: 5000 km, 10.000 km, 12.000 km, 15.000 km,
20.000 km and 30.000 km.
The following values may be selected for driver information modules (DIM) intended for miles: 7500 miles, 9000 miles, 12.000 miles, 12.500 miles and
18.000 miles.
Programming the time conditions for service
This parameter is used to set the number of months the vehicle may be driven before the service reminder indicator (SRI) lights.