XC60 FWD L6-3.2L VIN 96 B6324S2 (2010)
951 2620 Stripping tool See: Tools and Equipment/951 2620 Stripping Tool
951 2777 Hot-air gun See: Tools and Equipment/951 2777 Hot-Air Gun
951 2785 Crimping tool See: Tools and Equipment/951 2785 Crimping Tool
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Caution! As the SRS system is a safety system, it is extremely important that these instructions are carefully followed when carrying out repairs
in the cable harness.
Caution! Ensure that the new pin has the same type of surface treatment as the old one.
Warning! Do not carry out any work on the cable for the SRS system until the connector has been disconnected from the relevant airbag or
seat belt tensioner. There is otherwise a risk of static electricity deploying the component.
Preparatory work
Selection of repair kit, SRS system
Materials: SRS system repair kit for the selected car.
Note! Only special tools and materials from the SRS system repair kit for the selected car must be used. Choose a repair location where there is
plenty of room to guarantee that work is of the highest quality.
Cables should always be connected colour to colour. If the repair terminal's colour does not correspond with the vehicle, check on the wiring diagram for
the vehicle in question. In those cases the repair terminal has a completely orange cable, this is always connected to terminal No. 1. In those cases the
repair terminal has blue and brown cables, the blue is No. 1 and the brown No. 2.
Removing the battery lead and the ignition cable
Disconnect the battery negative cable.
Disconnect the relevant ignition cable.
Assembly
Cutting and stripping pairs of cables