XC60 FWD L6-3.2L VIN 96 B6324S2 (2010)
Seat Belt: Service and Repair
Quick-release Connector Belt
Quick-release connector belt
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Preparatory work
Adjusting the seat position
Move the seat as far forward as possible.
Removal
Removing front end mountings
Remove the front seat side panel. See: Side panel front seat See: Body and Frame/Seats/Service and Repair/Side Panel Front Seat.
Insert a screwdriver on the inside of the end mounting. Remove the seat belt by pressing the catch inwards and pulling upwards.
Remove the M10 screw and remove the end mounting.
Installation
Note! For tightening torques, see: Tightening torque, B6304T2, B6324S See: Body and Frame/Specifications.
Installing the front end mounting
Install:
-
the end mounting using the M10 screw. Tighten
-
the seat belt
-
the side panel as described in Side panel front seat See: Body and Frame/Seats/Service and Repair/Side Panel Front Seat.
Finishing
