XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)
-
Align gear sector: 999 5112 GEAR SECTOR See: Tools and Equipment/999 5112 Gear Sector.
-
Pull the flywheel / carrier plate towards the crankshaft using the 3 nuts on special tool 999 5678 Special screw See: Tools and Equipment/999
5678 Special Screw. The turned section of the nut must be turned towards the flywheel / carrier plate.
-
Install the other screws. Tighten. See Tightening torque See: Specifications/Mechanical Specifications/Tightening Torque
-
Replace the 3 special screws with new standard screws. Tighten. See Tightening torque See: Specifications/Mechanical Specifications/Tightening
Torque
-
Then angle tighten all 10 screws crosswise. Use 951 2050 BEVEL PROTRACTOR See: Tools and Equipment/951 2050 Bevel Protractor.
Tighten. See Tightening torque See: Specifications/Mechanical Specifications/Tightening Torque.
-
Ensure that the flywheel sensor and bracket are installed. Install the clutch driven plate and clutch.
Installing the gearbox
Install the gearbox:
-
manual transmissions. See Transmission, installing See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and
Repair/Removal and Replacement/Transmission, Installation
-
automatic transmissions. See Gearbox, installing See: Transmission and Drivetrain/Automatic Transmission/Transaxle/Service and
Repair/Removal and Replacement/Transmission, Installation.
Checking the engine:
Test drive the car to check the function of the engine and the gearbox.