Volvo Workshop Manuals
XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)
Maintenance > Fuses and Circuit Breakers > Fuse Block > Component Information > Service and Repair > Central Electrical Unit Engine Compartment > Page 2415
Replace the relay and/or shunt.
1. Wiring diagram for relevant model year
Installing the relay box in the passenger compartment
Install the relay box on the bracket
Press the relay box forward so that the catches engage in the bracket and "click"
Install the soundproofing panel on the driver's side.
Removing the control module
CAUTION: The customer-programmed data must be read off before the control module is replaced. The information must then be entered into the new
NOTE: The driver information module (DIM) must not be replaced at the same time. This would erase the mileage.
CAUTION: New software can only be ordered after the control module has been installed in the car. VADIS/VIDA reads off the new control module
NOTE: Remove fuses 11C/32, 11C/25 and 11C/21 before disconnecting the control module connector.
Always check that the control module and control module box connectors do not have bent or damaged terminals or sleeves. This may have been the
Removing the connector and the cover
Slacken off the screw holding the connector so that it releases from the threads. Check that the screw is free with your fingers.
NOTE: Do not damage the terminal pins.
|[PREV PAGE] [NEXT PAGE]|