Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)

Powertrain Management > Computers and Control Systems > Relays and Modules - Computers and Control Systems > Engine Control Module > Component Information > Diagrams > Diagram Information and Instructions > Page 4588

Page 29
background image

Press in the locking tab on the cable terminal and carefully pull out the cable and the cable terminal. Use tool 951 2812 Terminal removal tool See:
Tools and Equipment/951 2812 Terminal Removal Tool or tool 951 2637 Terminal removal tool  See: Tools and Equipment/951 2637 Terminal
Removal Tool , as illustrated.

Connector, assembling

Primary locking

Check that the cable terminal is undamaged.
Press the cable terminal into the housing.
Check that the cable terminal is properly locked by pulling carefully on the cable.

Secondary locking

Press the secondary lock into place.

Connector Type 1

Connectors, repair

Special tool 951 2637 Terminal removal tool  See: Tools and Equipment/951 2637 Terminal Removal Tool.

Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However,
the essential information in the illustrations is always correct.

Connector, dismantling

Secondary lock

Powertrain Management > Computers and Control Systems > Relays and Modules - Computers and Control Systems > Engine Control Module > Component Information > Diagrams > Diagram Information and Instructions > Page 4588

[PREV PAGE] [NEXT PAGE]