Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)

Powertrain Management > Computers and Control Systems > Relays and Modules - Computers and Control Systems > Engine Control Module > Component Information > Diagrams > Diagram Information and Instructions > Page 4624

Page 65
background image

Alternatively use tool 951 2852 Terminal removal tool See: Tools and Equipment/951 2852 Terminal Removal Tool as illustrated.

Installation

Primary lock

Check that the cable terminal is undamaged.
Press the cable terminal into the housing.
Check that the cable terminal is properly locked by pulling carefully on the cable,

The secondary lock

Press the secondary lock into place.

Finishing work

Install the relays.

Note! Take care with the positioning.

Install the relevant relay box.

Splicing the Cables

Splicing the cables

Strip the wire

Peel 5.0mm / 0.2 in of the insulation off the 4 cable ends (13/64 inches) using pliers951 2620 Stripping tool  See: Tools and Equipment/951 2620
Stripping Tool.

Powertrain Management > Computers and Control Systems > Relays and Modules - Computers and Control Systems > Engine Control Module > Component Information > Diagrams > Diagram Information and Instructions > Page 4624

[PREV PAGE] [NEXT PAGE]