Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)

Powertrain Management > Computers and Control Systems > Sensors and Switches - Computers and Control Systems > Transmission Position Switch/Sensor, A/T > Component Information > Adjustments > Page 4774

Page 2
background image

Remove the gear selector from the lever and the cable mounting from the transmission.
Unhook the mounting with the connector for the transmission from the bracket for the air cleaner (ACL) housing.
Remove the tie straps for the cable harness and the mounting in the cover for the control system.
Separate the connector for the gear-shift position sensor. Remove the gear-shift position sensor from the mounting.

Removing the gear-shift position sensor

Remove:

-

the lever for the gear shift linkage rod

-

the nut, locking washer and rubber seal securing the gear-shift position sensor to the gear shift linkage rod

-

the 2 screws

-

the gear-shift position sensor.

Installation

Installing the gear-shift position sensor

Install:

-

the sensor. Lightly tighten the 2 screws

-

the rubber washer, the lock washer and the nut on the sensor.

Tighten the nut. Lock the nut with the locking washer.

Powertrain Management > Computers and Control Systems > Sensors and Switches - Computers and Control Systems > Transmission Position Switch/Sensor, A/T > Component Information > Adjustments > Page 4774

[PREV PAGE] [NEXT PAGE]