Volvo Workshop Manuals
XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)
Powertrain Management > Computers and Control Systems > Transmission Position Switch/Sensor, A/T > Component Information > Adjustments > Page 4781
Note! When adjusting the gear-shift position sensor, press the tool down to the flat surfaces below the thread on the shaft.
Remove the lever. Install adjustment tool 999 5475 GAUGE See: Tools and Equipment/999 5475 Gauge on the gear shift linkage rod. Check that the
Adjusting the gear-shift position sensor
Remove the nut for the cable duct. Lift the cable duct away from the screw.
Installing the lever and gear selector cable
the lever on the gear shift linkage rod. Tighten to 16 Nm
the cable on the lever
the screws for the bracket. Tighten to 25 Nm.
Installing the air cleaner (ACL) housing
|[PREV PAGE] [NEXT PAGE]|