Do Not Sell My Personal Information
volvo Workshop Repair Guides

Volvo Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 11
background image

Remove:

-

the tie strap around the wiring above the pump

-

the level sensor by pressing in the two clips and pulling upwards

-

the thin pipe from the holder on the outside of the fuel tank unit

-

the wiring from the holder in the fuel tank unit.

Installation

Only applies to vehicles with parking heaters

If the vehicle has an engine block heater, drill out the hole connection in the fuel tank unit. Use a -4 mm drill bit. Transfer the dip pipe.

Installing the right-hand level sensor

Powertrain Management > Fuel Delivery and Air Induction > Fuel Tank > Fuel Gauge Sender > Component Information > Service and Repair > Left Fuel Gauge Sensor > Page 5086

< PREV PAGE NEXT PAGE >