Do Not Sell My Personal Information
volvo Workshop Repair Guides

Volvo Workshop Manuals

< PREV PAGE NEXT PAGE >
Page 32
background image

Remove:

-

the tie strap around the wiring above the pump

-

the level sensor by pressing in the two clips and pulling upwards

-

the thin pipe from the holder on the outside of the fuel tank unit

-

the wiring from the holder in the fuel tank unit.

Installation

Installing the right-hand level sensor

If the vehicle has an engine block heater, drill out the hole connection in the fuel tank unit. Use a -4 mm drill bit. Transfer the dip pipe.

Powertrain Management > Fuel Delivery and Air Induction > Fuel Tank > Fuel Gauge Sender > Component Information > Service and Repair > Left Fuel Gauge Sensor > Page 5107

< PREV PAGE NEXT PAGE >