Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)

Powertrain Management > Fuel Delivery and Air Induction > Relays and Modules - Fuel Delivery and Air Induction > Fuel Pump Control Unit > Component Information > Description and Operation > Page 5144

Page 4
background image

Check carefully that the seal is in place when the hatch is installed.

Open the vehicle's cable channel and lay down the cable harness.
Close the cable channel.

The control module shall be placed in the spare wheel well's rear part on the right side, between the two markings and below the bead of sealing
compound.
Remove the protective tape from the self-adhesive Velcro fastener and install the control module.
Plug in the connector from the cable harness to the control module.

To install, reverse the removal procedure.

Vehicles with fuel pump module originally located in spare wheel well's right trailing edge.

Install:

-

new control module

-

the connector to the control module

-

the luggage compartment mat/floor hatches

Powertrain Management > Fuel Delivery and Air Induction > Relays and Modules - Fuel Delivery and Air Induction > Fuel Pump Control Unit > Component Information > Description and Operation > Page 5144

[PREV PAGE] [NEXT PAGE]