XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)
Clean the mating surfaces thoroughly.
Installing the throttle body (TB)
Install
-
a new throttle body (TB) with a new gasket. Tighten to 10 Nm
Connect the throttle body (TB) connector
-
the tie strap at the connector
-
the pipe between the throttle body (TB) and the charge air cooler (CAC)
-
the intake manifold between the front cover plate and the air cleaner (ACL) housing
-
the battery negative lead. Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery, Disconnecting.
Note! After replacing the throttle unit, the throttle unit must be adapted using the vehicle communication input: "Adaptation of the electronic
throttle unit".
Remedy as necessary.
Throttle Body (Electronic Throttle Module, ETM), Replacing
Throttle body (electronic throttle module), replacing
Removal and Installation
Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However,
the essential information in the illustrations is always correct.
Removing the throttle body (TB)
Remove:
-
the battery negative lead. Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery, Disconnecting
-
the air intake between the front cover plate and the air cleaner (ACL) housing
-
the charge air pipe between the throttle body (TB) and the charge air cooler (CAC).