Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Body Control Module > Component Information > Service and Repair > Accessory Electronic Module (AEM) > Page 502

Page 2
background image

Note! Check that the control module's connectors are intact.

Installing the driver door module (DDM) 

Install the upper panel.
Position the control module in the hole on the door panel.
Check that the lower mounting for the control module is correctly located in the support on the door panel.
Press the control module into place.

Install:

-

the connectors

-

the nut and screw

-

the door panel, see Replacing the front door side panel See: Body and Frame/Doors, Hood and Trunk/Doors/Front Door/Front Door Panel/Service
and Repair/Removal and Replacement/Front Door Side Panel.

Ordering software

Order software for the driver door module (DDM) according to the table below.

Finishing

Initialise the window position in the communication input.

Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Body Control Module > Component Information > Service and Repair > Accessory Electronic Module (AEM) > Page 502

[PREV PAGE] [NEXT PAGE]