Volvo Workshop Manuals
XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)
Relays and Modules > Relays and Modules - Powertrain Management > Relays and Modules - Computers and Control Systems > Body Control Module > Component Information > Service and Repair > Accessory Electronic Module (AEM) > Page 532
Release the catch on the rear. Use a screwdriver
Lift and pull out the control module.
Check that the control module's connectors are intact.
Installing the control module
Press the control module into place so that the catch on the rear engages
Position the connector. Carefully press the connector down.
Note! The pins are fragile. Check that the connector goes straight down into the control module.
Tighten the screw for the connector
Check that the connector cover is correctly positioned. Remedy if necessary
Install the relays and shunts. For relay locations, see instruction Relay location.
Install the integrated relay / fusebox, see Installing the integrated relay / fusebox in the cargo compartment.
Order applicable software.
For the location of other relay and fuse boxes, see Relays, fuse boxes and wiring See: Power and Ground Distribution/Locations.
Passenger Door Module (PDM)
Passenger door module (PDM), replacing
Caution! New software can only be ordered when the control module is installed in the car. VIDA reads off the new control module identity
Always check that the control module and control module box connectors do not have bent or damaged terminals or sockets. This may have been the
Removing the passenger door module (PDM)
|[PREV PAGE] [NEXT PAGE]|