Workshop Repair Manuals

Volvo Workshop Manuals

[PREV PAGE] [NEXT PAGE]

volvo Workshop Repair Guides


XC70 L5-2.5L Turbo VIN 59 B5254T2 (2003)

Sensors and Switches > Sensors and Switches - Wiper and Washer Systems > Rain Sensor > Component Information > Diagrams > Diagram Information and Instructions > Page 1911

Page 8
background image

NOTE:  Do not apply rust solvent spray or grease to the Heated Oxygen Sensor (HO2S) or combined instrument panel connectors.

-

Ignition off

-

Disconnect the battery negative terminal

-

Use compressed air to clean the disconnected connector

-

Apply rust solvent spray 1161422 to the disconnected connectors

-

Blow clean using compressed air.

NOTE:  Do not fill the protective cover with grease.

-

Press grease, P/N 1161417-9, into the terminals directly from the tube

-

Check that all the cavities in the connectors are filled

-

Use a loose male pin to ensure that contact in sockets is good. The pin should remain in position when pulled gently.

Connector

Connectors, repair

Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However,
the essential information in the illustrations is always correct.

Connector

Sensors and Switches > Sensors and Switches - Wiper and Washer Systems > Rain Sensor > Component Information > Diagrams > Diagram Information and Instructions > Page 1911

[PREV PAGE] [NEXT PAGE]