XC70 AWD L6-3.2L VIN 98 B6324S (2009)
Note! Do not damage the dashboard and grille.
-
Remove the six screws in the bracket for the screen and pull it up.
-
Remove the connectors and place the module to one side.
Cable routing and connecting to the screen.
Illustration A
-
Take the remaining cable harness and connect it to the control module.
-
Route it under the member at the wheel housing, under the insulation and up to the door opening at the left-hand rear door.
Illustration B
-
Pull out the B pillar panel at the lower edge until the two clips release.
-
Continue to route the cable harness inside the B pillar panel and forwards in the car. Route the cable harness along the left-hand side, in front of
the floor and insulation panels, up to the front edge of the door opening.