XC70 AWD L6-3.2L VIN 98 B6324S (2009)
-
Remove the four screws on both sides.
-
Place the fender liner to one side and remove the screw at the upper edge of the cover on both sides.
-
Carefully pull off the ends of the bumper cover on both sides. They are secured by hooks at the top edge of the ends and at the lower edge of the
rear lights.
-
Pull off the bumper cover from the rear of the body, it is positioned in seven guides at the top edge of the long side.
Note! It is recommended that two people carry out this step to prevent damaging the bumper cover.
-
Place the bumper cover on a suitable surface.
Steps 10-11 apply to the XC70
