XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Route the pre-routed aerial cable (1) on the reverse of the air duct (at the front edge of the wheel arch) to the left-hand side of the seat belt lower
mounting and along the rear door sill. Continue inside the floor carpet to the front door opening
-
Clamp the cable harness in the hole in the front member for the seat mounting and in the rear hole in the horizontal panel at the right-hand side of
the seat. Use the tie straps (2) (from the kit).
-
Pull up the left and right sides of the carpet at the right-hand front seat slightly. Insert a cable (1) underneath the carpet at the front edge of the air
ducts on the right-hand side of the centre console. Pull out the cable at the right-hand door sill as illustrated
-
Tape the aerial cable (2) at the pre-routed cable. Route the cable to the right-hand side of the centre console
-
Route the aerial cable up at the air ducts and pull along in the centre console
-
Connect the aerial cable to the cable from the carphone holder.
Reinstall:
-
the floor carpets
-
the bracket with dashboard environment panel and control module in the centre console
-
the gear selector lever panel
-
the sill trim panels in the doors
-
the panel above the joints for the sill trim panels
-
the cover and panels for the seats
-
the right-hand side floor hatch
-
Reinstall the D-post panel and the headlining and any relevant connectors
-
Reinstall the folding panel.