XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Installing the mass movement sensor module (MMS)
Note! The location of the mass movement sensor module (MMS) is important for the function of the alarm. The sensor must be installed in the
recess to function correctly. The sensor must be installed so that it is straight. It must not be turned more than a maximum of 5°. The connector
must be to the right looking forwards in the car.
Connect the connector.
Remove the protective film from the tape. Only use the tape supplied with the volume sensor.
Press the sensor into place in the top of the headlining using the tape. Press by hand for at least 15 seconds.
Finishing work
Install:
-
the clips for the headlining
-
the screws for the cargo net holder
-
the covers over the screws for the cargo net holder
-
the cantrail. See Panel cantrail, replacing See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Panel Cantrail, Replacing
-
the panels for the D-posts. See Panel D-post, replacing See: Body and Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Panel
D-Post, Replacing.
Test the function.
