XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Remove the door panel
-
Remove the panel (4) for the cable lead-in
-
Drill out the rivets (5) from the existing loudspeaker. Use a 6 mm (1/4" ) diameter drill bit
-
Remove the loudspeakers and any rivet swarf from the rivet holes. Also remove any rivet swarf from the door.
-
Place the door panel on a suitable underlay, on a blanket or carpet, for example
-
Carefully cut the oil cloth out from the inside of the loudspeaker grille. Cut along the edges of the smaller round hole where the mid-range element
is to be positioned.
Note! Only cut through the oil cloth. Do not damage the underlying fabric.
-
Screw the new loudspeaker into place using the screws, washers and the nuts from the kit (1). The washers must be positioned under the screw
heads. Make a hole in the round piece of tape covering the screw hole to insert the rear screw
-
Reinstall the panel (2) for the cable lead-in.
-
Connect the connectors (3) to the loudspeaker and the module for the door controls
-
Reinstall the mechanical cable (4) on the door opener handle (5)
-
Reinstall the door panel, the treble loudspeaker and the door handle panel.
