XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Press in the fibre optic cable (1) (previously disconnected from the existing connector in the car) into the connector (3) until there is an audible
click.
Note! The fibre optic cables must be positioned opposite each other so that they meet in the connector.
-
Reinstall the blue catch
-
Press the fibre optic cable (4) (from the routed cable harness) into place in the same position in the connector (2) where the existing fibre optic
cable was disconnected previously. There must be an audible click
-
Reinstall the blue catch
-
Connect connectors 2 and 5 to each other.
Finishing work
-
Reinstall the fibre optic cables and secure the two loose connectors at the existing cable harness. Use tape or tie straps from the kit.
Note! Ensure that the fibre optic cables do not have a radius of more than 30 mm (1 3/16") and are not positioned so that there is a risk of
being trapped or rubbed.
-
Remove the shim under the polystyrene insulation and then reinstall. (Applies to cars up to and including model year -2004 (CH -133999))
-
Fold back the carpet. (Applies to cars up to and including model year -2004 (CH -133999))
-
Reinstall the side panel and cover using screws. Tighten the screws for the load securing eyelets. Tighten to 24 Nm (18 lbf.ft)
-
Reinstall the D-post panel and connect the connector for the D-post loudspeaker (if applicable)
-
Connect the connector for the lighting in the rear headlining (applies to cars with three rows of seats)
-
Reinstall the rear headlining
-
Reinstall the C-post panel. (Applies to cars up to and including model year -2004 (CH -133999))
-
Reinstall the seat. Tighten the screws. Tighten to 48 Nm (35 lbf.ft). (Applies to cars up to and including model year -2004 (CH -133999))
-
Reinstall the panel over the door sill and the panels over the seat mountings as well as the panel at the bottom edge of the B-post panel. (Applies to
cars up to and including model year -2004 (CH -133999))
Note! See the illustration!
Press the seat belt into the end mounting.
Note! A click should be heard when the seat belt is locked correctly into the end mounting.
