volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Detachable Tow Hitch|Page 14702 > < Detachable Tow Hitch|Page 14700
Page 4
background image

Tow hitch, detachable

Note! The ball and ball holder with the accompanying components are separate component kits and are not included in the kit but must be
purchased separately, see the list.

Note! Kit contents: 

1. Cross member
2. Screw M12x110 (x6)
3. Spacer washer, left-hand
4. Spacer washer, right-hand
5. Strap (purchased separately)
6. Bracket (purchased separately)
7. Nut M6 (purchased separately)
8. Protective cover (purchased separately)
9. Ball (purchased separately)

10. Washer (purchased separately)
11. Nut (purchased separately)
12. Ball holder (purchased separately)
13. Rubber tabs (x4) (purchased separately)
14. Locking bolt (purchased separately)
15. Cotter pin (purchased separately)
16. Cover
17. Mounting pin (x2).

Type approval of the tow hitch is shown in a table in the instructions.

Illustration A

Applies to cars with two rows of seats

-

Fold up the centre rear floor hatch (1) slightly

-

Remove it by pulling it off the mountings at the front edge

-

Remove the storage box underneath and lift it out. If the floor hatch has a carrier bag holder on the underneath, it is secured by a strap on each of
the shorter sides of the storage box. The straps must be undone.

Illustration B

Detachable Tow Hitch|Page 14702 > < Detachable Tow Hitch|Page 14700