volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Trailer Connector|Part 1|Page 15179 > < Trailer Connector|Part 1|Page 15177
Page 4
background image

-

Fold back the carpet.

-

Remove the clips on the lower edge of the folding panel (on both the right-hand and left-hand sides) by pressing in the centre of the clip until an
audible snap is heard.

-

Remove the clips.

-

Unscrew the front clips.

-

Turn the knob (1) on the right-hand and left-hand sides 90°.

-

Fold the panels inwards. Lift the panels out.

-

First, pull the trunk lid sill trim panel (2) forwards until the two clips on the right-hand and left-hand sides release. Pull forcefully but carefully
since the panel is fitted tightly. Pull the panel straight up until the four clips in the lower edge release.

-

Remove the wiring (3) for the cargo compartment lighting.

-

Lift out the sill trim panel.

-

Remove the dummy plug from the hole in the body, see the illustration (battery draining is not affected).

Note! It is only possible to connect one of the functions (rear fog lamps, charging or reversing lamps) according to applicable steps below. You
can also choose not to connect any of the functions.

Trailer Connector|Part 1|Page 15179 > < Trailer Connector|Part 1|Page 15177