XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
the 3 vertical support struts which are secured with 3 screws and 3 clips
-
the 7 hooks for the rear section at the bottom edge.
Hint: Detach the top edge first.
Transfer the bumper padding which is secured at 3 points.
Installing the rear bumper casing
Note! For tightening torques, see Specifications See: Specifications.
Install:
-
the foam for the rear section
-
the rear section on the bumper cover.
Hint: First press the upper edge of the rear section into place. Then guide the hooks on the bottom edge of the bumper casing into the rear section and
press them into place.
Install:
-
the bumper cover
-
the 2 connectors
-
the 4 M8 nuts. Tighten
-
the 2 covers.
Press the sides of the bumper into place.
Install:
-
the 2 rivets under the car
-
the 4 pre-punched soundproofing sections
-
the 1 M8 screw for the battery cover and the bracket. Tighten
-
the outer side floor.
Fold down the floor hatch.