XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Remove the screw for the drive shaft. Use a screwdriver as a counterhold on the brake disc.
Knock the end of the drive shaft into the hub. Use a brass drift.
Disconnect the ball joint pinion from the control arm. Use tool 999 7062.
Install cap nut 7062-1 on the ball joint pinion.
Tighten the nut against the control arm.
Then turn back one turn to form a gap between the cap nut and the control arm.
Position the extractor on the control arm. Detach the ball joint from the control arm.
Remove the four nuts and screws holding the steering gear to the sub-frame.
Remove the power steering line from the clips on the sub-frame.
Remove:
