volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Bushing Rear Sub-Frame, Replacing|Page 15839 > < Bushing Rear Sub-Frame, Replacing|Page 15837
Page 6
background image

Note! Only applies to vehicles with 6-cylinder engines.

Pay attention to the following when removing propeller shaft

Follow instructions. Refer to: Propeller shaft, special information  

Note! Only applies to cars with AWD.

Remove:

-

the 4 screws for the propeller shaft

-

the propeller shaft

-

the power supply cable and the clamps for the Active on Demand coupling (AOC).

Lowering the sub-frame

Position a lifting table under the sub-frame.
Apply the lifting table so that the load is taken off the sub-frame screws. Remove the bracket for the fuel pre-filter and brake pipe. Remove the sub-frame
screws with accompanying washers and brackets. Carefully lower the sub-frame approximately 100 mm.

Remove:

Bushing Rear Sub-Frame, Replacing|Page 15839 > < Bushing Rear Sub-Frame, Replacing|Page 15837