XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Install the four nuts and the screw holding the steering gear. Use new nuts and a new screw.
Tighten to 50 Nm.
Applies to right-hand drive cars:
Install nut (A), holding the lower half of the collision protection. Tighten to 50 Nm.
Installing the delivery line from the steering gear
Install the delivery line from the steering gear on the mountings on the sub-frame. Install any fuel line for the engine block heater.
Installing the screws for the engine mounting to the engine
Reinstall the screws holding the engine mounting to the engine. Tighten to 35 Nm. Angle-tighten 90 degrees.
NOTE: Use new screws.
Installing the vibration damper (6-cylinder engines only)
