XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Remove the cover and the screws underneath for the rear headlining
-
Carefully pry off the panel at the rear edge. Use a plastic weatherstrip tool
-
Pull the rear edge of the panel downwards until all clips on the inside have released
-
If the car has lighting in the panel, disconnect the connector
-
Pull the panel backwards to release it.
-
Pull off the left-hand D-post panel starting at the top edge. Then pull downwards until the three clips on the inside have released. Do not damage
the panel
-
Remove the panel by pulling upwards slightly and unhooking it from the side panel
-
Disconnect the connector if the car has a loudspeaker in the D-post
-
Repeat the operation on the right-hand side.
Illustration A shows the removal of the cover for the load securing eyelets
Applies to all models
-
Fold out the load securing eyelet
-
Insert a scriber with an angled tip into the hole in the top of the cover
-
Turn the scriber so that the angled tip engages in the reverse of the cover (1). Pull the cover off
