XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Lift up the stop catch (A) and fold back the base unit (B).
-
Fold the base unit back until two clicks are heard and the catch pops up.
Locking the base unit
-
The base unit can be equipped with a lock which is supplied with the kits for the different load units that can be combined with the base unit. To
install the locking cylinder in the lock housing, see the relevant load unit instructions.
Note! On certain car models it may be necessary to saw/cut a piece out of the bumper casing to obtain room for the lock.
Safety checks before a journey
Caution! Make sure that all screws, nuts and tensioning straps are firmly tightened before setting off. Check them at regular intervals.
Damaged tensioning straps must be replaced with new ones. The base unit must not be used as an attachment point for towing. The base unit
must not be used when driving over terrain.
Note! If the car's license plate is obscured by the base unit there is an extra license plate holder with lighting that is available as an accessory.
This should then be used.
