XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Right-hand side:
-
Measure up to drill the cable lead-in in the upper of the rear section plates as illustrated
-
Pre-drill using a 3 mm (1/8") diameter drill bit. Then drill out the hole to a diameter of 8 mm (5/16"). Use an angle drill and short drill bits.
-
Cut a 2 mm (5/64") wide groove through the plate leading in to the hole.
Applies to all models
Left-hand side:
-
Cut out the rear section at the existing cut out as marked in the illustration.
Applies to cars with reversing warning systems