XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Left-hand side:
-
Measure up to drill the cable lead-in on the left and right-hand sides of the cut-out in the upper of the rear section plates as illustrated
-
Pre-drill using a 3 mm (1/8") diameter drill bit. Then drill out the holes to a diameter of 8 mm (5/16"). Use an angle drill and short drill bits.
-
Cut a 2 mm (5/64") wide groove through the plate leading in to the holes on both sides of the cut-out.
Right-hand side:
-
Press up the tab on the plate. Insert the cable in the previously drilled hole. The cable must be positioned as illustrated.
