XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Take two clips from the kit. Install them on the front face of the net pocket in approximately the position shown in the illustration.
-
Bend in the front face of the net pocket towards the side panel
-
Align the entire front face of the net pocket so that it is parallel with the edges of the panel as illustrated and the lower face so that it is against the
floor hatch
-
Raise the lower clip so that its lower edge is 50 mm (2") from the floor hatch
-
Ensure that the clips are against the panel. Mark the panel for drilling using an awl or scriber through the holes in the clips.
-
Angle out the front face of the net pocket
-
Drill out the holes. Use a 3 mm (1/8") diameter drill bit. Use a 10 mm (25/64") drill stop
-
Remove any swarf.
