XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Release the two elastic attachments in the inside/reverse of the backrest.
Remove the three half moon clips from the inside of the reverse of the backrest.
Pull off all the upholstery.
Installing backrest cushion upholstery
Note! For tightening torques, see See: Specifications
Install:
-
the upholstery on the backrest
-
the three half moon clips on the inside of the reverse of the backrest
-
the two elastic attachments in the inside of the reverse of the backrest
-
one half moon clip in each side of the front-rear channels.
Install the upholstery up to the first lateral channel. There must be two half moon clips per each front-rear channel.
Install the upholstery all the way down.
Install five half moon clips at the bottom edge of the backrest.
Fold the backrest to the normal position.
Install:
-
the backrest adjustment knob. Push the knob straight in
-
the lumbar support knob
-
the cover.
Tension the lumbar support.
Installing the front seat
Install:
-
the seat in the car
-
the connector
-
the seat belt
-
the side panel. See Side panel, replacing See: Service and Repair/Removal and Replacement/Front Seat, Driver's Seat, Front Seat/Side Panel,
Replacing
-
any remaining connectors
-
the 4 M10 screws. Tighten.
Remove the ground lead (if applicable).
