XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Clean the brake pipes terminals at the master cylinder and ABS unit.
Place paper under the master cylinder to avoid brake fluid spillage.
Remove the brake pipes from the master cylinder and ABS unit. Install sealing plugs.
Installation
Installing the brake pipes
Note! For tightening torques, see Specifications See: Specifications/Tightening Torque.
Note! The new brake pipe must be bent into the correct shape when installing. This is important otherwise the pipe may be subject to stresses
when it is in place.
Install the brake pipes. Tighten. See: Tightening torque See: Specifications/Tightening Torque.
Installing the integrated relay/fusebox
Install the box in its mounting.
Install:
-
the cable harness
-
the connector
-
the 2 x M6 screws for the mounting
-
the 2 x power cables
-
the M8 nut to secure the power cables.
Installing the air cleaner (ACL) housing
Press the air cleaner (ACL) housing into place.
Install the air hoses and the connector.
Installing the upper torque rod
Install:
-
the engine stabilizer brace
-
the M12 screw and nut for the engine mounting
-
the 4 x M10 mounting screws for the torque rod.
Finishing
