XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Secure the cable in its clamps and on the welding rod.
Bend the welding rod over the end of the cable.
Install the cable in the hole in the floor.
Press the rubber grommet into the hole in the floor.
Press the mechanical cable into place in its mounting between the heat shield and the fuel tank.
Also press the mechanical cable between the fuel tank and the edge of the heat deflector.
Lower the vehicle.
Take hold of the welding rod. Pull the mechanical cable with the sleeve through the bodywork and up to the parking brake lever.
Remove the welding rod.
Install the cable end in the segment.