volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Vacuum Brake Booster|Testing and Inspection|Page 8392 > < Vacuum Brake Booster|Testing and Inspection|Page 8390
Page 7
background image

-

Ignition off

-

Before the next corrective action - wait approximately 3 minutes after switching the ignition off (system relay disconnected).

Pump the brake pedal a few times to that all negative pressure in the power brake booster disappears.
Check the function of the vacuum pump by pressing the brake pedal with the ignition on. The Vacuum pump should start and run for a few seconds to
build up a new vacuum and then stop.

Is the function correct?

Yes - Procedure complete

No - Fault-tracing information

-------------------------------------------------

Fault-tracing information

Information

The fault should have been detected and remedied. As this is not the case fault-tracing has failed.
Exit fault-tracing for this diagnostic trouble code (DTC) or make another attempt.

Do you want to exit fault-tracing?

Yes - Exit Fault-tracing

No - Attempt New Test

Vacuum Brake Booster|Testing and Inspection|Page 8392 > < Vacuum Brake Booster|Testing and Inspection|Page 8390