volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Fuel Pipe Auxiliary Heater, Replacing|Page 11380 > < Fuel Pipe Auxiliary Heater, Replacing|Page 11378
Page 5
background image

Seat, Passenger Seat, Seat/Upholstery Backrest Cushion Center (Second Row), Replacing and Upholstery backrest cushion outer (second row) 
See: Body and Frame/Seats/Seat Cover/Service and Repair/Rear Seat, Passenger Seat, Seat/Upholstery Backrest Cushion Outer (Second Row) 

-

the right-hand side panel in the cargo compartment / third row of seats. See Side panel cargo compartment, replacement See: Body and
Frame/Interior Moulding / Trim/Trim Panel/Service and Repair/Side Panel Cargo Compartment, Replacement 

-

the right-hand section of the air duct to the rear right-hand air vent in the C-post

-

the insulation

-

the four nuts

-

the inspection hatch for the fuel tank unit.

Disconnect the quick-release connector (see the illustration). Pull off the fuel hose.

Installing the fuel line for the engine coolant heater

Install the fuel line.
Connect the fuel line to the fuel pump (FP).
Check that the tilt angle on the fuel pump (FP) is 15°.
Connect the fuel line from the fuel pump (FP) and forward to the sub-frame and fuel line.
Install the fuel line on the clip and the fuel terminals.

Final check

Test run the heater. Check the function of the heater. See Engine coolant heater, test running See: Testing and Inspection/Component Tests and General
Diagnostics/Engine Coolant Heater, Test Running.
Check for leakage in the fuel lines and hoses.
Check that no diagnostic trouble codes (DTC) have been stored during the repair work.
Screw the inspection hatch for the fuel tank unit into place.

Fuel Pipe Auxiliary Heater, Replacing|Page 11380 > < Fuel Pipe Auxiliary Heater, Replacing|Page 11378