XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
the bumper shell. See Casing bumper front, replacing See: Body and Frame/Bumper/Front Bumper/Front Bumper Cover / Fascia/Service and
Repair
-
the seal on the condenser
-
the pipe coupling from the receiver drier.
Slacken off the 2 lower mounting screws for the condenser.
Remove the condenser.
Installing the condenser
Note! Always use new O-rings lubricated with oil.
Position the condenser.
Check that the condenser is in the correct position in relation to the air conditioning aggregate.
Tighten the lower 2 screws for the condenser.
Position the hose/pipe from the compressor in the mounting clips. Then place the hose/pipe in the pipe coupling on the left-hand side of the condenser.
Note! The hose/pipe must be secured to the retaining clip to ensure that it is correctly positioned before the protective panel is installed.
Install:
-
the hose connector on the receiver drier and tighten
-
the splashguard under the car
-
the connector on the receiver drier
-
the seal on the condenser.
Tighten:
-
the upper mountings for the condenser
-
the screw for the hose connector from the compressor on the left-hand side of the condenser.