XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Caution! Tighten to the correct torque. If the knock sensor is over-tightened it may deform. If it is too loose it may disrupt the function of the
Install the new sensors using the screws in the cylinder block
Route the cables on the outside of the starter motor bracket
Align the sensors (looking from the front)
The cable from the sensor at cylinder 3 = 3 o'clock and from the sensor for cylinder 5 = 6 o'clock
Tighten the knock sensors. See Tightening torque See: Engine, Cooling and Exhaust/Engine/Specifications/Mechanical Specifications/Tightening
Press the knock sensor (KS) connectors together. Check that the wiring is in the correct position. Use a clamp if necessary.
Install the intake manifold according to Intake pipe/gasket, replacement See: Engine, Cooling and Exhaust/Engine/Intake Manifold/Service and Repair.
Connect the battery lead. See Battery, disconnecting See: Starting and Charging/Battery/Service and Repair/Procedures/Battery, Disconnecting.