XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Push the upholstery and padding at the side of the SIPS tube to one side.
-
Insert the U bracket (1) through the SIPS tube from underneath. The U bracket studs must protrude outwards towards the upholstery on top of the
SIPS tube.
-
Make a cut in the upholstery for the studs. Use a knife.
Note! Take care not to damage the heated seat cushion.
-
Insert the U bracket.
-
Thread the anchor mounting (2) onto the U bracket. Ensure that the anchor mounting lies against the SIPS tube.
-
Install and tighten the nuts (3). When tightening the nuts, take care to tighten them alternately to prevent distortion of the mountings. Also take
care to conceal any upholstery and foam that may come between the anchor mounting and SIPS tube. These must lie be opposite each other after
tightening. Tighten to 7 Nm (5.3 lbf.ft.).
-
Install the rubber caps (4) from the kit, on the protruding studs.
-
Fold the backrest back into place.
ISOFIX Guide
ISOFIX guide
