XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Disconnect the ball joint pinion from the control arm. Use tool 999 7062.
Install cap nut 7062-1 on the ball joint pinion.
Tighten the nut against the control arm.
Then turn back one turn to form a gap between the cap nut and the control arm.
Position the extractor on the control arm. Detach the ball joint from the control arm.
Installing the wheel spindle
Install
-
the wheel spindle on the trailing arm
-
a new nut on the ball joint. Tighten. Use a Torx wrench as counterhold.
Note: Make sure that the mating surfaces on the ball joint and link are clean.
Clean the splines on the drive shaft.
Turn in the wheel spindle and locate the drive shaft in the hub.
Install drive shaft screw and finger-tighten.
Lubricate the screw.
Install
-
both screws retaining the spring strut in the wheel spindle. Use new screws and nuts.
Adjust the position of the wheel spindle and spring strut. Tighten. Use bevel protractor 951 2050.
Install
-
the anti-roll bar link to the spring strut. Use a new nut. (M12) Counterhold using a Torx wrench so that the boot is not damaged
-
the ABS sensor cable
-
ABS sensor onto the wheel spindle. Tighten the ABS sensor. (M6).
Note: Ensure that the sensor seat in the wheel spindle is absolutely clean. Clean the ABS sensor with a soft brush.
Install