volvo Workshop Repair Guides

Volvo Workshop Service and Repair Manuals

Reading and Clearing Diagnostic Trouble Codes|Page 10841 > < Reading and Clearing Diagnostic Trouble Codes|Page 10839
Page 35
background image

Checking the Error Message

Checking the error message

Trouble-shooting information

Note! Many serious error messages cannot be erased from the display window. This remains in the display window until the error concerned
has been dealt with.

Does the error message indicate a serious error?

Yes - Remedy as required

No - Procedure complete

-------------------------------------------------

Trouble-Shooting Information

Trouble-shooting information

Condition

-

No SWM diagnostic trouble codes are displayed in the CEM

-

No diagnostic trouble codes are displayed in the SWM.

Possible source

-

Defective windscreen-wiper switch

-

Defective control unit.

Fault symptom[s]

-

Windscreen wipers operate at low speed.

Checking the Windshield Wiper Switch

Checking the windshield wiper switch

Checking components

Activate the windshield wiper switch. Read off the status.

Hint: If the wiper switch status is OK the fault is not in the steering wheel module (SWM).

Was the wiper switch status OK?

Yes - No Fault Found

No - Replacing the component

-------------------------------------------------

Replacing the component

Replace the wiper switch

Other information:

-

To replace the wiper switch, see Washer / wiper switch, replacing See: Sensors and Switches/Sensors and Switches - Wiper and Washer

Reading and Clearing Diagnostic Trouble Codes|Page 10841 > < Reading and Clearing Diagnostic Trouble Codes|Page 10839