XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
Reinsert the ignition key and turn it to position "I" to prevent the steering lock from engaging.
-
Turn the steering wheel a quarter turn so that the holes on the reverse of the steering wheel are accessible.
-
Insert a screwdriver in the hole (2) on the reverse side of the steering wheel at right angles to the rear surface.
Insert the screwdriver as far as possible to locate the end of the locking spring (1).
-
Position the end of the screwdriver on the top of the spring clip as illustrated
-
Pry the screwdriver upwards towards the upper edge of the hole (2) so that the end of the screwdriver presses the spring clip down (1) until one
side of the steering wheel module springs out and releases from the mounting
-
Turn the steering wheel a half turn in the opposite direction. Carry out the same operation on the other side
-
Turn the steering wheel to a neutral position.
-
Fold the steering wheel module out
-
Remove the two connectors (1) for the ignition cables for the airbag. First press in the catches on the sides. Then pull the connectors straight out.
Note! The connectors are tightly secured. However, tools must not be used when removing.
-
Place the steering wheel module to one side.
Remove:
