XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Note! Some variation may occur. However, the essential information in the illustrations is always correct.
Early design of the bushing
This replacement method applies to the early design of the bushing. The figure illustrates the early design.
See Bushing rear sub-frame, replacing See: for the replacement method for the new design.
Removal
Remove:
-
the rear wheels
-
the screws in the bracket under the exhaust pipe.
Position a lifting table under the sub-frame.
Apply the lifting table so that the load is taken off the sub-frame screws.
Remove the 2 x rear screws.
Carefully lower the sub-frame approximately 70 mm.
Removing the bushing