XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
-
the drive shaft screw. Use a screwdriver as a counterhold on the brake disc
-
the locating pin holding the brake disc
-
the brake disc. Detach the end of the drive shaft in the hub by knocking the drive shaft into the hub approximately 10 - 15 mm. Use a rubber or
copper mallet
-
the tie rod ends from the steering arm.
Measure the position of the wheel spindle and spring strut.
Remove both the screws retaining the spring strut in the wheel spindle.
Press out the wheel spindle. At the same time pull the drive shaft from the transmission.
Hang the drive shaft from a hook 999 5045.
Note: Take care not to damage the drive shaft boot.