XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Tighten to 105 Nm and angle-tighten to 90°. Use protractor 951 2050 BEVEL PROTRACTOR See: Tools and Equipment/951 2050 Bevel Protractor.
Install:
-
the anti-roll bar link to the spring strut. Use a new nut. Tighten to 50 Nm. Counterhold using a Torx spanner to prevent damage to the boot.
-
The ABS sensor. Tighten to 10 Nm.
Note! Ensure that the ABS sensor seat in the stub axle is absolutely clean. Clean the ABS sensor with a soft brush.
Install:
-
the ABS sensor cable in the bracket.
-
the wheel. See Installing wheels See: Wheels and Tires/Wheels/Service and Repair.
Align the wheels. See Wheel alignment, checking / adjusting See: Alignment/Service and Repair.
Rear Suspension
Shock absorber rear, replacing
Special tools:
999 5500 Socket Upper Nut Rear Shock Absorber See: Tools and Equipment/999 5500 Socket Upper Nut Rear Shock Absorber
999 5659 Tension caliper See: Tools and Equipment/999 5659 Tension Caliper
Note! The illustrations in this service information are used for different model years and/or models. Some variation may occur. However, the
essential information in the illustrations is always correct.
Removal
Preparatory work
Raise the vehicle.
Remove the wheels.
Install tensioner999 5659 Tension caliper See: Tools and Equipment/999 5659 Tension Caliper. See Tensioner 999 5659, User instructions See: Service
and Repair/User Instructions.
