XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Seals and Gaskets: Service and Repair
Replacing the Pinion Seal for the Bevel Gear
Replacing the pinion seal for the bevel gear
Special tools:
999 5069 Extractor See: Tools and Equipment/999 5069 Extractor
999 5504 Press Tool, Drive Flange See: Tools and Equipment/999 5504 Press Tool, Drive Flange
999 5652 Counterh. See: Tools and Equipment/999 5652 Counterh.
999 5653 Punch See: Tools and Equipment/999 5653 Punch
999 5682 Tensioner Band See: Tools and Equipment/999 5682 Tensioner Band
999 5893 Puller See: Tools and Equipment/999 5893 Puller
999 7057 Counterhold See: Tools and Equipment/999 7057 Counterhold
999 7058 Adapter See: Tools and Equipment/999 7058 Adapter
Note! As the illustrations in this service information are used for different model years and/or models, some variation may occur. However, the
essential information in the illustrations is always correct.
Note! Check that the parking brake is not applied or that a gear/position P is engaged.
Removal
Removing the three-way catalytic converter (TWC)
Remove the catalytic converter. See Three-way catalytic converter (TWC), replacing See: Engine, Cooling and Exhaust/Exhaust System/Catalytic
Converter/Service and Repair.
Note! The rear pipe must be supported at the front. Tensioner band 999 5682 Tensioner band See: Tools and Equipment/999 5682 Tensioner
Band can be used to support the pipe.
Marking the propeller shaft/carrier plate
Mark the propeller shaft CV joint in relation to the bevel gear flange
Remove the screws from the propeller shaft.
Use counterhold 999 7057 Counterhold See: Tools and Equipment/999 7057 Counterhold.
Removing the propeller shaft