XC90 L5-2.5L Turbo VIN 59 B5254T2 (2004)
Shift Solenoid: Service and Repair
Solenoid control system, replacing
Note! As the illustrations in this service information are used for different model years and / or models, some variation may occur. However,
the essential information is always correct.
Replacing and checking solenoids
Preparations
Note! The operations which affect the cable harness and connectors and mountings for the control system solenoids must not be carried out
when replacing the solenoids or the control system.
Remove. See Temperature sensor fluid, transaxle, (TFT) See: Sensors and Switches - Transmission and Drivetrain/Sensors and Switches -
A/T/Transmission Temperature Sensor/Switch/Service and Repair.
Disconnect the connectors from the solenoids.
Check the resistance in S1-S5
Location Of Components (Solenoids)
Note! Readings should be taken at approximately 20°C.
Solenoid S1
Measure the resistance between the pin in the solenoid connector and the transmission ground terminal.
Correct value: 12-16 ohms.
Solenoids S2-S5
Measure the resistance between the pin in the solenoid connector and the transmission ground terminal.
Correct value: 11-15 ohms.
If the resistance of any of solenoids S1-S5 is incorrect